You asked: How do you change positions in Fusion 360?

How do I change my origin point on Fusion 360?

Select the Point to Point or Point to Position Move Type.

  1. Select a point on one of the bodies as the origin point.
  2. Select the origin in the browser tree as the target point.

How do you move individual parts in Fusion 360?


  1. Use the “Bodies” selection for the Move tool and select the bodies you want to position, which you can then move as a block.
  2. Create a component and insert all of the bodies you’d like to move, then use the “Components” selection on the move tool and move the whole component.

What is capture position in Fusion 360?

Solution: Any time you move components around in Fusion 360 you will be asked if you’d like to “Capture Position.” Capture Position records the current position of all components in the design. It also adds a capture position feature in the parametric timeline.

How do you change XYZ in Fusion 360?

Click the bubble with either the account name initials or account picture in the top right corner of Fusion 360. Select Preferences. In the General preferences tab is an option called “Default Modeling Orientation”. Use this dropdown to select Z up instead of Y up.

IT IS INTERESTING:  How do I get my navigation wheel back in Revit?

Where is fusion workspace Xbox 360?

The Model workspace has been renamed the Design workspace. Sculpt, Surface, and Sheet Metal are available the tabs shown on the toolbar at the top of the screen.

Where is mesh to BRep?

Mesh to BRep is only available in Direct Modeling Mode. To enter direct modeling mode, right-click on the Fusion 360 Browser > select “Do Not Capture Design History.” A warning dialog will appear.

How do I move origin in fusion?

How can I move the origin there?

I guess I need to:

  1. make a new (trash) sketch to be able to project from the applicable geometry and generate a new point that I would like to be my origin.
  2. select move tool -> bodies.
  3. select bodies.
  4. click “origin point” in move dialogue box, select new origin point.

How do you use assembly in Fusion 360?


  1. Create a new design for the assembly and save it.
  2. Right click on one of the components in the data panel, then click “Insert into current design”.
  3. Select a location for the component, then click ok.
  4. After the component is imported, it can be assembled by using the joint command.
Special Project