# Frequent question: Which command is used to give wall thickness in a House plan?

Contents

## How are wall thickness established for the floor plan drawing?

When drawing manually, set dividers to proper wall thickness. When drawing using CADD, use the OFFSET, DOUBLE LINE, or similar command to draw the wall at the proper thickness. ​When locating windows and doors on drawing, place a centerline through the middle of the opening for frame walls.

## How many inches does a wall take?

A two-by-four wall stud is 3 ½ inches wide, and an interior wall typically has ½-inch drywall installed on both sides, bringing the wall thickness to 4 ½ inches. Walls that contain plumbing, such as walls behind sinks, however, should be thicker than standard walls.

## What is minimum wall thickness?

Minimum wall thickness gives the absolute minimal thickness of a pipe or structure to contain its contents. … Minimum wall thickness in design is based on the pressure of the vessel or pipe’s contents, the material’s allowable stress and the outer diameter of the pipe.

## What is the standard wall thickness for a house?

Average Wall Width of Interior Walls

Most interior walls are constructed with 2-by-4 framing, and each 2-by-4 has a nominal width of 3 1/2 inches. Drywall typically covers both sides, and it’s usually 1/2 inch thick, which makes the wall 4 1/2 inches thick.

IT IS IMPORTANT:  You asked: What are the features corrected by AutoCAD?

## How do you extend wall studs?

Frame your wall extension on the subfloor by nailing the top and bottom plates to the studs with 12d nails. Hoist the framed wall into place. Nail the wall to the floor and ceiling joists or blocking. Face-nail the end stud of the extension to the end stud of the existing wall with 10d nails.

## How thick are exterior walls?

External walls are generally 10 to 12 inches wide. Homes that are built with rammed earth or heavy exterior masonry will have thicker walls. There is no limit to how thick an exterior wall can be.

## How thick should walls be metric?

Wall thickness

SUGGESTED WALL THICKNESS FOR DIFFERENT MATERIALS
Material Exterior Wall Interior Wall
Poured Concrete (not reinforced) 12.5-20 cm. 12.5-20 cm.
Poured Concrete (reinforced) 12.5 cm. 12.5 cm.
Stone 30-37.5 cm. 25 cm.